Sitting at idle or turn off engine? - Fuelly Forums

Click here to see important news regarding the aCar App

Reply
 
Thread Tools Display Modes
 
Old 06-30-2008, 04:32 AM   #1
Registered Member
 
cat0020's Avatar
 
Join Date: Jun 2008
Posts: 278
Country: United States
Sitting at idle or turn off engine?

From the 201 Tips To Save Gas:

33. Don't start and stop needlessly
Don't start and stop the engine needlessly. Idling your engine for one minute consumes the same gas amount as when you start the engine, which for your information is a lot!

How much fuel does an average car enigne use at start up?

I got to thinking: if a car engine is idling at 6-800 prm sitting at a red light for 10 seconds, that's approx. 60-80 rpm that the engien turned while idling. Depending on the engine size, could that be similar amount of fuel used to start an engine?

On my 250cc scooter, I turn off the engine and coast to a traffic light when I can estimate that I will have to come to a complete stop and wait for a few seconds for the light to change. Since my scooter's carb and valves are adjusted that it would fire up the engine within one crank revolution, it's not such a big deal to turn off and restart the engine numerous times. But then again, my 250cc scooter uses less than 1/10 of the fuel of a 2.6 liter engine per engine revolution.
__________________

__________________
Master your environment and you will survive just fine.
Chances favor the prepared mind.
cat0020 is offline   Reply With Quote
Old 06-30-2008, 04:57 AM   #2
Registered Member
 
GasSavers_RoadWarrior's Avatar
 
Join Date: Feb 2008
Posts: 1,652
'96 up cars break even at 10secs apparently, however some say emissions break even at 5 mins, older carbed cars have been reported as having 5-10min break-evens, 85ish-96 cars are reported to have 2 min break evens.
__________________

__________________
I remember The RoadWarrior..To understand who he was, you have to go back to another time..the world was powered by the black fuel & the desert sprouted great cities..Gone now, swept away..two mighty warrior tribes went to war & touched off a blaze which engulfed them all. Without fuel, they were nothing..thundering machines sputtered & stopped..Only those mobile enough to scavenge, brutal enough to pillage would survive. The gangs took over the highways, ready to wage war for a tank of juice
GasSavers_RoadWarrior is offline   Reply With Quote
Old 06-30-2008, 05:07 AM   #3
Registered Member
 
cat0020's Avatar
 
Join Date: Jun 2008
Posts: 278
Country: United States
Question

Quote:
Originally Posted by RoadWarrior View Post
'96 up cars break even at 10secs apparently, however some say emissions break even at 5 mins, older carbed cars have been reported as having 5-10min break-evens, 85ish-96 cars are reported to have 2 min break evens.
Can you be more specific about this "break even" business?
what breaks even with what? on what size engine? what rpm range?

5 minutes idling, that's over 3000-4000 rpm in the engine, that's quite a bit of fuel burned for sitting without motion, does a car engine require that much fuel at start up?
__________________
Master your environment and you will survive just fine.
Chances favor the prepared mind.
cat0020 is offline   Reply With Quote
Old 06-30-2008, 05:46 AM   #4
Registered Member
 
theholycow's Avatar
 
Join Date: Apr 2008
Posts: 6,624
Country: United States
Send a message via ICQ to theholycow Send a message via AIM to theholycow Send a message via MSN to theholycow Send a message via Yahoo to theholycow
RW's talking about the difference between the steady consumption at idle and the large amount of fuel required to start the engine. Starting does use more fuel than idling for a few seconds, and the break-even point is a question of just exactly how many seconds of idling uses the same amount of fuel as starting.

To start the engine, it needs a very rich squirt of fuel (choke on your lawmower, an actual squirt in my 1980 Buick, or just long injector openings on a modern car), and then it will idle fast for a few seconds even if it's already warm.
__________________
This sig may return, some day.
theholycow is offline   Reply With Quote
Old 06-30-2008, 08:05 AM   #5
Registered Member
 
SolidLiquidSnake's Avatar
 
Join Date: Jun 2008
Posts: 34
Country: United States
I find turning off the engine for a few seconds to be useless waste of your starter, time, and possbily gas if you have car off shorter amount of time.. What I would like to know is if bump starting a manual tranny would be better, I think it would but that means I have to buy a new car... damn
SolidLiquidSnake is offline   Reply With Quote
Old 06-30-2008, 08:23 AM   #6
Registered Member
 
GasSavers_RoadWarrior's Avatar
 
Join Date: Feb 2008
Posts: 1,652
Quote:
Originally Posted by theholycow View Post
RW's talking about the difference between the steady consumption at idle and the large amount of fuel required to start the engine. Starting does use more fuel than idling for a few seconds, and the break-even point is a question of just exactly how many seconds of idling uses the same amount of fuel as starting.

To start the engine, it needs a very rich squirt of fuel (choke on your lawmower, an actual squirt in my 1980 Buick, or just long injector openings on a modern car), and then it will idle fast for a few seconds even if it's already warm.
Yup, more modern cars have a more controlled warm startup, measuring the gas, some older FI systems are known to just turn the injectors full on while cranking, changing to bank firing them rich at high idle for a minute or two, before passing back to closed loop.
__________________
I remember The RoadWarrior..To understand who he was, you have to go back to another time..the world was powered by the black fuel & the desert sprouted great cities..Gone now, swept away..two mighty warrior tribes went to war & touched off a blaze which engulfed them all. Without fuel, they were nothing..thundering machines sputtered & stopped..Only those mobile enough to scavenge, brutal enough to pillage would survive. The gangs took over the highways, ready to wage war for a tank of juice
GasSavers_RoadWarrior is offline   Reply With Quote
Old 06-30-2008, 08:53 AM   #7
Registered Member
 
goofy1's Avatar
 
Join Date: May 2008
Posts: 169
Country: United States
i've done better shutting off my car if i know i'm going to sit at a light for 30secs or more. u have to know your car and the stop lights in the area for it to work. its useless if your just going to sit there for anything less then that
__________________
"But Doc, we dont' have enough road to get it up to 88 miles per hour"
goofy1 is offline   Reply With Quote
Old 06-30-2008, 10:16 AM   #8
Registered Member
 
palemelanesian's Avatar
 
Join Date: Apr 2013
Posts: 364
Country: United States
I shut off if it's going to be more than 10 seconds. Seems to work...

See this study: http://www.slate.com/id/2192187/ Tested - restarting uses as much fuel as 6 seconds of idling.
palemelanesian is offline   Reply With Quote
Old 06-30-2008, 10:35 AM   #9
Registered Member
 
Join Date: Apr 2008
Posts: 1,264
Country: United States
Location: up nawth
I usually don't because it takes my car time to get back into lean burn after a shutdown.

But, you should pay more attention to Pale Melanesian because he is doubling his mileage.

It definitely increases wear and tear on the starting system.

My alternative is to maximise my DFCO and try to not sit at the light in the first place.

If you drive a repetitious route where you know when the lights are going to be green, try longer DFCO events to time your arrival at the light to when it's green, if that is possible in your situation.

Your objective is to arrive at the light after it has changed and traffic starts moving. DFCO is the same (as far as fuel use is concerned) as turning off the engine and restarting it when you cruise through the intersection without stopping at all.

This works with manual transmissions, but no where near as well with automatics.

regards
gary
__________________
R.I.D.E. is offline   Reply With Quote
Old 06-30-2008, 10:39 AM   #10
Registered Member
 
palemelanesian's Avatar
 
Join Date: Apr 2013
Posts: 364
Country: United States
Good points there.

Hadn't though of the lean burn issue (how many times have I said that? apologies to the VX'ers). My "normal" engine goes into closed loop within a second after restarting.

Also, a warmed-up restart is almost instant, so there's not a huge amount of wear going on. Admittedly, there is more starter wear than not doing it, but it's minimal.

DFCO into a light is another good approach. Six of one, half dozen of the other.
__________________

palemelanesian is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are Off


Similar Threads
Thread Thread Starter Forum Replies Last Post
Incorrect Milage Calcuatlion PatM Fuelly Web Support and Community News 4 07-17-2009 07:21 PM
ECT Analyzer/manual TC lockup GasSavers_Bruce Transmissions and Running Gear 60 04-01-2008 10:37 AM
Timing chain and FE bowtieguy Experiments, Modifications and DIY 22 11-11-2007 08:48 AM
Car trouble woes Fourthbean General Maintenance and Repair 10 07-30-2007 04:54 AM
How far do you drive daily? OdieTurbo General Fuel Topics 56 03-31-2007 01:49 AM

» Fuelly iOS Apps
Powered by vBadvanced CMPS v3.2.3


All times are GMT -8. The time now is 09:52 PM.


Powered by vBulletin® Version 3.8.8 Beta 1
Copyright ©2000 - 2024, vBulletin Solutions, Inc.