Air Dam Project
 

After doing the measurements, looking for attachment points etc, just need some nuts and screws.

Material being used:
Landscape Edging
All Round - 3/4" 24ga
Nuts & Screws

The material is cut at least. Will see tomorrow how easy it will be to get the right screws out. On my car I must work under the radiator. Otherwise, there are no spots to connect to.

Hopefully I will not be too low on the front.

The sides will be another project for another day.

Joel

Dont forget the pics.

My problem is that I don't have a digital camera...Would be nice though. Will see about finding one.

It is finally done, so I hope. A few hours and a heat gun. For my first time doing this, I am pleased with the results. Looks like it is part of the car with the curves on the front.

As for the height. The peak in the middle is at 6 1/2", the other parts came out to 6" off the ground. Looking forward to the drive, to see what we get for mileage.

The total expenses were as follows:
Landscape edging: Free
Heat Gun: Free
Screws and Nuts: $4
All Round: $5

Total Expenses:$9

P.S. Will post pics as soon as I can.

Hey, Antares2k6,any new info on the airdam? Still haven't made mine(1995 Regal) yet and free feedback/input could help.Got a pic yet?