Fuelly Forums - Scangauge questions

Page 2 of 2

Show 40 post(s) from this thread on one page

Fuelly Forums (https://www.fuelly.com/forums/)

- Hypermiling (https://www.fuelly.com/forums/f33/)

- - Scangauge questions (https://www.fuelly.com/forums/f33/scangauge-questions-8995.html)

Project84

06-17-2008 10:29 AM

No, really mine was never getting past the first quarter mark, so I repaced the thermostat and checked the coolant temp sensor... now it gets between first quarter and halfway... maybe its another coolant temp sensor gone bad... my Saturn (S-Series in general) is known for it.

GasSavers_BEEF

06-18-2008 03:30 AM

I'd block the grill and see what happens as far as temps. around here we have seen 100 deg days and mine seems to stay pretty firm even though I am running a WAI and have the grill blocked about 80 percent.

Project84

06-18-2008 04:17 AM

I'm working on my HAI and the left over material may be used as a grill block, just depends on how silly I'm feeling this evening when I get back to it.

OfficeLinebacker

06-20-2008 02:23 PM

Quote:

Originally Posted by PaleMelanesian (Post 106397)

You're right about the speed calibration. Just re-check it after a whole tank and fine-tune based on the results.

Cutoff is for DFCO. If your car has DFCO, you want to set it to the TPS reading at idle. Verify with the open/closed loop gauge - open loop means you're in DFCO mode. You should see 9999 mpg and open loop at the same time, and lower mpg / closed loop any other time, with the transition between the two aligned. You may have to adjust the cutoff +- 1 to get it dialed in.

Not really, they recommend the idle reading +4 as the default.

All times are GMT -8. The time now is 09:29 PM.

Page 2 of 2

Show 40 post(s) from this thread on one page